New to Radix Fidem?

Visit the Introduction and User Guide thread to get acquainted with us.

Automatic registration is currently closed. Please email admin@radixfidem.org if you'd like to register for the forum.


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Happy Monday!
#8
(10-31-2018, 06:27 AM)IainH Wrote:
(10-30-2018, 10:02 PM)IainH Wrote: On my way to work on HAPPY MONDAY my car died.halfway to work. Fortunately, I managed to pull into Cheeks. Cheeks crossroads convenience store, unfortunately I had to push the vehicle out of the way, fortunately the vehicle in question is a Honda crv and the parking lot is flat. I called work and then Michelle. She came and took me home. About an hour later I roused our mechanic and he fetched the car with his rollback. Sunday I had winterized my bike, drain oils, add Stabil™ to the gas drained the fuel line and removed the fuel bowl from the carburetor and emptied it. Then I took the front wheel off in preparation to work on the forks, that's replace the seals and take the opportunity to install upgraded springs. I had to dewinterize the bike which took the rest of the day. I rode to work today (Tuesday) in 36° I was wrapped up good but, still froze. The next time you're out drive at 55 mph with the windows down and the heat off, if you sit on the roof for twenty miles well...... Randall, our mechanic called and said the battery had a bad cell. Guess what, it will be ready tomorrow. One more iceberg run.
I'll add this, I have to wait until there is enough light to see before I leave. The headlight on my bike is less effective than a kerosene lamp. I bought this bike because it had 2000 miles on a rebuilt engine, my intent was to have a rolling project that I could ride while upgrading. It was never intended to be used as daily transportation. The design of the front forks is such that I can't add oil without first removing them. I have bad fork seals and am losing oil which adversely affects their performance, this is dangerous. I'm in the danger zone every bump. Our fallback vehicle needs wheel bearings, it's been parked for a while. It must be fixed soon. 

PLEASE, pray for my safety while riding.

Of course we will pray!
Church elder at radixfidem.org
Blog: jaydinitto.com
Reply


Messages In This Thread
Happy Monday! - by IainH - 10-29-2018, 04:35 AM
RE: Happy Monday! - by jaybreak - 10-29-2018, 05:53 AM
RE: Happy Monday! - by forrealone - 10-29-2018, 08:08 AM
RE: Happy Monday! - by Ed Hurst - 10-29-2018, 08:09 AM
RE: Happy Monday! - by jaybreak - 10-29-2018, 08:42 PM
RE: Happy Monday! - by IainH - 10-30-2018, 10:02 PM
RE: Happy Monday! - by IainH - 10-31-2018, 06:27 AM
RE: Happy Monday! - by jaybreak - 10-31-2018, 08:14 AM
RE: Happy Monday! - by IainH - 10-31-2018, 12:34 PM
RE: Happy Monday! - by Ed Hurst - 10-31-2018, 12:34 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)